Proper maintenance of your Pentair Clean & Clear® Plus Cartridge Filter ensures efficient operation and prolongs the life of your pool system. This checklist provides step-by-step instructions based on the informative video by Pentair. Always refer to the user manual for detailed guidance, and contact us if needed. Watch the original video by Pentair here.
Safety First 🚨
- Beware of Trapped Air: Trapped air in the filter can cause dangerous pressure buildup. Always release air before servicing the filter.
- Shut Off Power: Turn off power at the breaker and automation system (if applicable).
Tools Needed 🛠️
- 7/8-inch socket wrench
- Dead blow hammer
- Garden hose with spray attachment
Step-by-Step Cleaning Checklist
- Prepare the System
- Turn off the automation system or switch the system to service mode.
- Shut off all power at the breakers.
- Release Pressure
- Open the high-flow manual air relief valve on the filter lid.
- Open the drain plug at the bottom of the tank to release water.
- Disassemble the Filter
- Use the 7/8-inch socket wrench to loosen the barrel nut.
- Remove the clamp, lid, and O-ring carefully.
- Set all parts on a clean surface.
- Clean the Cartridges
- Remove the cartridges and rinse thoroughly with a garden hose.
- Spray at a downward 45° angle, ensuring you clean between pleats.
- For deep cleaning, soak cartridges in a commercial filter cleaner or a solution of 1 cup trisodium phosphate or dish detergent to 5 gallons of water. Rinse thoroughly.
- Inspect and Clean Other Parts
- Check and clean the bottom manifold, tank bottom, and air bleed tube.
- Inspect the O-ring for debris or damage.
- Reassemble the Filter
- Replace the clean cartridges, ensuring they are fully seated.
- Reinstall the top manifold, O-ring, and lid.
- Place the band clamp securely and tighten the barrel nut using the wrench.
- Tap the clamp with the dead blow hammer to evenly distribute tension.
- Restart the System
- Open the manual air relief valve.
- Turn the power back on and start the pump.
- Stand clear of the filter during startup.
- Close the air relief valve once a steady stream of water flows.
Troubleshooting Tips 🔧
- If water leaks or the system doesn’t pressurize properly, shut off the pump immediately and release all pressure.
- Inspect and re-tighten the clamp as needed, following safety procedures.
Regular maintenance keeps your filter running safely and efficiently. For further assistance visit Pentair.com or contact us for Pentair Technical Support.
